Submerged-Arc Welding

The assemblies concept of the KA welding automat series is the basis for different technological system solutions. In combination with the Kjellberg welding power sources they form numerous possibilities for tailor-made solutions.

Manual Submerged-Arc Welding

The wire feeding unit DV UP-H with integrated control unit and four-roller drive is designed for manual submerged-arc welding and optimised for use in connection with the hand torch UP-H 500. The system is suited for welding large seam geometries without any possibility of automation, e.g. frames of windmill towers or large fittings of containers and pipes. The wire feeding unit can be used for welding with solid wires as well as filler wires. The machine can be operated in two-stroke or four-stroke mode. Kjellberg’s GTH 802 power source is ideally suited for this process. Nominal values for welding current, arc voltage and welding speed can easily be pre-adjusted. The flux supply is realised with a mobile pressure tank. The easy-to-handle hand torch is equipped with a separate flux shutoff device that enables the operator to directly start and end the welding process. The well-protected electronics allows a high degree of mobility of the SA welding unit. The currentless wire threading makes it easier to weld even under difficult conditions.